Heras banner
sizes and fixing
The sizes that fit standard Heras panels and gates, how to measure your own fence, and how to tie a banner on properly.

Standard Heras panel and banner sizes
A standard Heras-style temporary fence panel is 3.5 m wide and 2 m high. Banners are made slightly smaller than the panel so they sit inside the frame, with room for cable ties around the edge.
- Fence panel
- Panel 3.5 × 2 m. Banner typically about 3.3 to 3.4 m wide by 1.75 to 1.8 m high.
- Pedestrian gate
- Gate about 1 to 1.2 m wide. Banner typically about 1 m wide by the same height as the fence banners.
- Vehicle gates
- Usually made from pairs of leaves. One banner per leaf, sized to that leaf, so the gate still opens.
- Other panels
- Lighter and anti-climb panels, and panels from other makers, vary. Measure inside the frame before ordering.
Sizes differ a little between printers, so always check the size against your own fence. A banner that is too big cannot be tied tight and will flap.
How to measure a Heras panel for a banner
- Measure inside the frame. Take the width and height between the inside edges of the outer tube, not the overall panel size.
- Check the corners. Many panels have rounded top corners. Ask for angled or rounded banner corners so the banner does not bunch there.
- Allow for the clamps. Couplers join panels at the top and bottom. Note where they sit so eyelets do not land on them.
- Count every panel. Count fence panels, pedestrian gates and vehicle gate leaves separately, and note any panels that face inwards.
- Note the run order. If one design runs along the fence, list the panels from one end so each banner can be numbered.

Fixing a banner to Heras fencing
- Eyelets
- Around the edge of the banner, typically every 50 cm, with one in each corner.
- Cable ties
- One tie through each eyelet and around the frame, pulled tight so the banner is taut. Use UV-stable ties outdoors.
- Bungees
- An alternative on windy sites, as they give a little rather than snapping or tearing the eyelet.
- Sequence
- Start at the corners, then the top edge, then the sides and bottom, keeping the tension even.
- Stability
- A covered panel catches much more wind than a bare one. Add feet, ballast blocks or stays as the fence supplier advises, and use mesh on exposed runs.
Heras banner size FAQs
What size is a Heras fence banner?
For a standard 3.5 × 2 m panel, about 3.3 to 3.4 m wide and 1.75 to 1.8 m high. Gates need their own sizes.
What is the standard size of Heras fencing?
The common panel is 3.5 m long and 2 m high, standing in rubber or concrete feet and joined with couplers. Other heights and lighter panels are also used.
Can one banner cover two panels?
It is possible but not advised. Panels move independently, so a banner across the joint strains its eyelets. One banner per panel, with the artwork set out across them, is neater.
Should Heras banners be mesh or PVC?
Mesh on most sites. See mesh or PVC for the full comparison, and our Heras fence banners page for what we supply.
Fill in what you can and send it. A rough idea is enough to start.
Or email info@perimeterprint.co.uk. We reply with a price, or with any questions we need answered first.